Pari Vios LC Sprint Aerosol Nebulizer Compressor

What to buy with LC Sprint Aerosol Nebulizer Compressor

• Pari LC Plus Reusable Nebulizer with Pediatric Aerosol Mask
• PARI LC PLUS Compressor Nebulizer System Medication Cup
• Pari Wing Tip Tubing

How to set up Pari Sprint Aerosol Nebulizer Compressor?

1. Clean/Disinfect Nebulizer Cup: Properly clean and disinfect your nebulizer prior to first use. Re-assemble nebulizer.
2. Set-up Compressor: Place the compressor on a flat, stable surface free of dust. Avoid cushioned, upholstered or carpeted surfaces. Make sure power switch is turned to, the “OFF” position. Plug power cord into wall outlet
3. Connect Tubing To Compressor: Insert one end of Wing Tip tubing to the air outlet on the compressor. It should fit snugly.
4. Load Medication: Open the inspiratory valve cap of nebulizer by lifting the cap. Pour the prescribed dose of medication into the nebulizer cup. Never fill past the max. fill line of 8 ml.
5. Attach Mouthpiece or Mask: If using the mouthpiece, attach the mouthpiece to the nebulizer outlet with the expiratory valve facing up. Then close the inspiratory valve cap by pressing firmly on the nebulizer top. If using the Bubbles the Fish II Pediatric Mask provided with the unit, attach the mask directly to the nebulizer outlet. If using another type of mask refer to the mask instructions.
6. Attach Tubing To Nebulizer Cup: Firmly press the other end of the Wing Tip tubing to bottom of PARI reusable nebulizer
7. Starting Treatment: Sit in a relaxed, upright position and turn the compressor “ON”.
8. Nebulizer Position: Place the mouthpiece on top of tongue and close lips around it. Take slow, deep breaths. As you inhale, the inhalation valve opens.
9. Breathing: For mouthpiece, inhale and exhale slowly through your mouth. As you exhale, the valve on the mouthpiece opens to allow the exhaled mist to escape. For mask, place mask over nose and mouth and inhale and exhale slowly.
10. Complete Treatment: Continue until the medication is gone or you hear a slight “sputtering” sound. Turn compressor OFF.

How to clean Pari Vios Aerosol Nebulizer?

1. Disconnect the tubing from the air intake on the bottom of the nebulizer cup.
2. If there is any moisture (condensation) in the tubing, let the compressor run with only the tubing attached for 2-3 minutes. The warm air from the compressor will dry out the tubing. Alternatively, you can dry the tubing by removing it from the compressor and hanging it up with the “ends down” to allow any moisture (condensation) to drain out and evaporate. Use a clean damp cloth to wipe the exterior of the tubing.
3. Disassemble reusable nebulizer parts
4. Wash all parts including the Bubbles II pediatric mask with warm water and liquid dish soap. DO NOT WASH THE TUBING. Rinse the reusable nebulizer parts and Bubbles II pediatric mask thoroughly with warm water and shake out the water.
5. Air dry or hand dry nebulizer parts on a clean, lint-free cloth. Reassemble nebulizer when parts are dry and store.
6. You can also wash all parts of the reusable nebulizer on the top shelf of a dishwasher. DO NOT PLACE BUBBLES II MASK IN DISHWASHER. DO NOT WASH TUBING. Place the reusable nebulizer parts in a dishwasher basket, then place the basket on the top rack of the dishwasher. Remove and dry the parts when the dishwasher cycle is complete.

Vios Sprint Aerosol Nebulizer Compressor Specification

Pari Vios LC Sprint Nebulizer Compressor Warranty

5-Year Warranty

Customer Reviews