Features of Omron CompAir Nebulizer
- Omron Compressor Nebulizer is intended to provide air to the pneumatic nebulizer in order to aerosolize medications for inhalation by the patient
- It is a lightweight and small nebulizer for easy portability
- Designed for use with pediatric (defined by the prescribed medication) and adult patients in the home, hospital, and sub-acute settings
- 3.5 times smaller and 75% lighter than most compressor nebulizers
- Fast, efficient operation with a nebulization rate of 0.30mL/minute and particles as small as 5 um MMD
- The quiet motor runs at just 46dB (or about the volume level of your refrigerator)
What does Omron CompAir Nebulizer Include?
Omron CompAir Compressor Nebulizer System includes:
- Compressor
- Nebulizer kit
- Air tube (PVC, 100cm)
- 5 spare air filters
- Mouthpiece
- AC adapter
- Storage bag
- Instruction manual
Omron NE-C801 Nebulizer User Manual
What to buy with Omron Compressor Nebulizer
How to Use Omron Compressor Nebulizer System?
Preparing the Omron Compressor
- Insert the power plug on the AC adapter into the power connector on the back side of the compressor. Plug the AC adapter into the electrical outlet.
- Lift up the mouthpiece and the cap to remove them from the nebulizer kit
- Rotate the inhalation top counterclockwise and lift to remove the inhalation top from the medication cup.
- Add the correct amount of prescribed medication to the medication cup.
- Make sure that the baffle is securely attached to the inhalation top.
- Attach the desired inhalation accessory.
Attaching the Air Tube
- Twist the air tube plug slightly and push it firmly into the air tube connector on the upper side of the compressor.
- Twist the air tube plug slightly and push it firmly into the air tube connector on the bottom of the nebulizer kit.
- Use the nebulizer kit holder as a temporary holder for the nebulizer kit.
Using the Omron Compressor Nebulizer
- Hold the nebulizer kit straight in front of the face.
- Turn the power switch to the on position. As the compressor starts, nebulization begins and aerosol is generated. To stop nebulization, turn the power switch to the off position.
- Inhale medication as instructed by your physician or licensed healthcare practitioner.
- Complete the treatment.
- Turn the power switch to the off position. The compressor turns off and nebulization stops.
- Disconnect the air tube from the nebulizer kit. Hold the air tube plug and gently pull down to disconnect the air tube plug from the air tube connector on the bottom of the nebulizer kit.
- Check the air tube. No condensation or moisture should remain in the air tube. If any condensation or moisture remains in the air tube, remove the moisture from the air tube. Follow the directions below:
- Make sure the air tube is still connected to the air tube connector on the upper side of the compressor.
- Press the power switch on. The compressor will start and pump air through the air tube to expel the moisture.
- Press the power switch again to turn the compressor off.
- Disconnect the air tube from the compressor. Hold the air tube plug and gently pull the air tube plug off the air tube connector on the upper side of the compressor.
- Unplug the AC adapter from the electrical outlet.
How to Clean the Compressor Nebulizer by Omron?
- Remove the inhalation accessory (mouthpiece, optional masks, or optional nosepiece) from the nebulizer kit. Disconnect the air tube from the nebulizer kit.
- Gently twist the inhalation top counterclockwise and lift to separate the nebulizer into two sections.
- Discard the remaining medication in the medication cup.
- Rinse all the parts with hot tap water. Hand dry or air dry in a clean environment using a soft, clean, lint-free cloth.
- Assemble the nebulizer kit and store it in a dry bag.
How to Change the Air Filter?
- Pull the air filter cover to remove it from the back side of the compressor.
- Remove the dirty air filter.
- Insert a new air filter.
- Put the air filter cover back on the compressor.
Omron CompAir Compressor Nebulizer Specifications
Particulars |
Specifications |
Rating (AC adapter) |
100V to 240V ~ 350mA, 50/60Hz |
Rating |
12V 0.8A |
Operating Condition |
Intermittent operation 20min. ON / 40min. OFF |
Operating Temperature/ Humidity |
+10°C to +40°C, 30% to 85% RH |
Storage Temperature/ Humidity/Air Pressure |
-20°C to +60°C, 10%RH to 95%RH, 700hPa to 1060hPa |
Weight |
Approximately 270g (compressor only) |
Classification |
Class ll equipment, Type B applied part |
Warranty
3-Years Manufacturer's Warranty