Graham Field Lumiscope Lumineb II Nebulizer Compressor

What to buy with Lumiscope Lumineb II Nebulizer Compressor?

• Graham Field Mouthpiece
• Graham Field Crush Resistant Oxygen Tubing
• Graham Field Complete Nebulizer Set

How to use Lumiscope Lumineb II Nebulizer Compressor?

• Place your Lumineb II on a flat and stable surface. Be sure that you can easily reach the controls while you are seated
• Gently twist the top part of the nebulizer assembly counter-clockwise to disassemble the nebulizer
• Fill the bottom section of the nebulizer with the medication prescribed by your physician. Be sure that the nebulizer cone is put inside the bottom section
• Replace the top part of the nebulizer and gently twist clockwise to reassemble the nebulizer. Make sure both sections are connected properly
• Attach one end of the air tube to the base of the nebulizer
• Attach the other end of the air tube to the air outlet on the top of the Lumineb II
• Attach the standard mouthpiece to the top of nebulizer assembly
• If using an optional mask, attach the mask to the top of nebulizer assembly
• Make sure the On/Off switch is in the Off position, then plug the power cord into an electrical outlet
• Flip On/Off switch to On position to begin your prescribed treatment
• When your treatment is finished, shut off the Lumineb II and unplug it from the electrical outlet
   

Note:
The compressor motor has a thermal protector which will shut off the unit before it overheats. When the thermal protector shuts the unit off:

• Switch off the Lumineb II.
• Unplug the unit from the electrical outlet.
• Wait 30 minutes for the motor to cool down before another treatment.
• Make sure the air openings are not obstructed.

Cleaning Lumineb II Nebulizer

• Disconnect the air tube, nebulizer, and mouthpiece
• Gently twist the nebulizer to open it
• Rinse the nebulizer and mouthpiece or mask with water
• Dry with a clean soft towel or allow to air dry
• Reassemble the nebulizer when completely dry
• Wipe the compressor with a damp cloth and allow to air dry
• Never use powdered cleaners or soap pads on the compressor, as it may damage the finish of the unit

Disinfecting Lumineb II Nebulizer Compressor

• Use one part white vinegar to three parts distilled water. Make sure the mixed solution is enough to submerge the nebulizer and mouthpiece
• Wash the nebulizer, mouthpiece and/or mask in warm water with a mild detergent, then rinse the detergent solution out with hot tap water - Submerge the cleaned components in the water and vinegar solution for thirty minutes

Changing the Lumiscope nebulizer Filter

• Remove the filter cover on the top of the compressor unit - Replace the old filter with a new one
• Replace the filter cover
• Use only Lumiscope nebulizer filters
• Do not substitute cotton or any other materials. Do not wash, clean or re-use a filter
• Never operate your Lumineb II without a filter
• Change the filter every 30 days or when it turns gray

Graham Field Lumineb II Nebulizer Compressor Specifications

Warranty

Five year limited warranty

Customer Reviews