Drive Airial MEDNEB Plus Compressor Nebulizer

How do you use a Medneb Compressor Nebulizer?

How to Operate the Compressor?

• Before each use, inspect the Compressor and nebulizer cup assembly for any damage or wear, replace if needed.
• Place the Compressor on a table or a flat stable surface
  • Be sure to can easily reach the controls when seated
  • Do not use this device on the floor
• With the power switch in the O (OFF) position, plug the power cord into an appropriate electrical wall outlet.
• Connect one end of the tubing to the compressor air-outlet connector.
• Assemble the nebulizer cup and add indicated medication to the nebulizer cup before use.
• Attach the other end of the tubing into the air-inlet connector found at the bottom of the nebulizer cup.
• Turn on the Compressor by pressing the power switch to the I (ON) position and begin treatment.
• If treatment needs to be interrupted, simply press power switch to O (OFF) position.
• When the treatment is complete, turn off the compressor by pressing the power switch to O (OFF) position and unplug the unit from the electrical outlet.
• Always unplug this device immediately after use.
• Do not use this product in or near explosive environments, or where aerosol (spray) products are being used.
• Do not pump combustible liquids or vapors with the product or use in or near an area where flammable or explosive liquids or vapors may exist.
• Do not operate this product in an oxygen enriched environment, i.e. oxygen tent or oxygen hood.
• Use only in well ventilated areas.

How to Take the Treatment using the Drive Nebulizer?

• Sit up straight and breathe-in deeply
• Breathe-in so deeply that it feels as though the lungs are completely full of air and inhaling any additional air is impossible
• If possible, hold breath for 1-2 seconds unless directed otherwise by physician and then slowly exhale through the nebulizer mouthpiece or mask
• Holding breath for 1-2 seconds after inhaling the medication allows for optimal absorption of medication in the lungs
• Repeat this breathing pattern for the entire treatment

How to clean the Medneb Plus Nebulizer?

1. With power switch in the “Off” position, unplug power cord from wall outlet.
2. Disconnect tubing from the air-inlet connector and set aside.
3. Disassemble mouthpiece or mask from cap. Open nebulizer by turning cap counterclockwise and remove baffle.
4. Wash all items, except tubing, in a hot water with a little dish-washing detergent solution. Rinse under hot tap water for 30 seconds to remove detergent residue. Allow to air dry.
5. Drive Reusable Nebulizer is dishwasher safe, but do not place any Drive Disposable Nebulizer parts in an automatic dishwasher; doing so could cause damage

How to clean the Drive Airial Compressor?

1. With power switch in the “Off ” position, unplug power cord from wall outlet.
2. Wipe outside of the compressor cabinet with a clean damp cloth every few days to keep dust-free.
3. Do not submerge in water; doing so will result in compressor damage.

For more information on care and usage of the product, please view Drive Medneb Plus Nebulizer User Guide

Nebulizer Compatibility Guide
 

Airial MEDNEB Plus Specifications

MEDNEB Plus Warranty

• 5 year limited warranty
• This warranty does not cover device failure due to owner misuse or negligence, or normal wear and tear
• The warranty does not extend to non-durable components, such as filters, rubber accessories, and rubber grips, which are subject to normal wear and need periodic replacement

Customer Reviews