Drive Heavy Duty Suction Machine

More Information

• Warning:
  - Close supervision is necessary when this product is used by, on, or near children or invalids
  - Never operate this product if:
• It has a damaged power cord or plug
• It is not working properly
• Dropped or damaged
• Dropped into water
  - Return the product to an authorized Drive medical equipment service center for examination and repair
  - Keep the power cord away from heated surfaces
  - Never use while drowsy or asleep
• Note: The motor of this compressor has a thermal overload protector. If the motor overheats, the overload protector will shut off the motor. If this occurs, turn the ON/OFF switch to the OFF position and allow the motor to cool (approximately 5 minutes). Restart compressor. If the compressor fails to start, wait an additional 5 minutes before attempting to restart. If this fails, inspect the fuses on your suction unit. If the unit still does not restart, call your medical equipment provider immediately
• Cleaning & Maintenance:
  Clean Collection Bottle:
  - Turn off the suction unit and allow vacuum to drop, then disconnect AC power source
  - With the collection bottle still in the holder, remove the collection bottle lid. The bottle can now be taken out of the holder to be emptied
  - Collection bottle should be emptied after each use
  Collection bottle should be thoroughly cleaned after each use by one of the following three methods:
  - Wash in a hot water/dishwashing detergent solution and rinse with clean, hot tap water. Then wash in one part vinegar to three parts hot water solution. Rinse with hot tap water and air dry
  - Wash with rubbing alcohol and air
  - Wash with a commercial (bacterial-germicidal) disinfectant, follow disinfectant manufacturer recommended instructions and dilution rates carefully
  Clean Tubing:
  - Disconnect the tubing from the unit
  - Tubing should be rinsed thoroughly after every use by running hot tap water through it followed by a solution of one part vinegar to three parts hot water
  - Rinse with hot tap water and air dry
  - Keep the outer surface of the tubing clean by wiping with a clean, damp cloth
  Bacteria Filter Change:
  - Bacteria filter should be replaced as needed. If overflow occurs, change the filter immediately
  - Remove filter by disconnecting it from tubing connected to pressure adjusting valve and tubing connected to collection bottle lid assembly
  - Replace with a new Drive bacteria filter and connect to above two tubing. Additional filters can be purchased from an authorized dealer

Specification

Warranty

2 Year Limited Warranty

Customer Reviews