Pari LC Plus Reusable Nebulizer

How to use Pari Plus Nebulizer Set?

1. Clean/Disinfect Nebulizer Cup: Clean and disinfect Pari LC Plus prior to first use. Re-assemble Nebulizer when dry.
2. Connect Tubing To Compressor: Connect one end of the tubing to the compressor air outlet. The tubing should fit snugly. Plug in compressor to an electrical outlet.
3. Load Medication: Remove the Nebulizer. Insert by twisting counter-clockwise until it stops and lift up. Pour the prescribed dose of medication into the Nebulizer Cup. Never fill past the max fill line of 8ml. Replace the Nebulizer Insert ensuring the two alignment rings are lined up with each other.
4. Attach Mouthpiece or Mask: If using the Mouthpiece, attach the Mouthpiece to the Nebulizer outlet with the expiratory valve facing up. Then attach the Inspiratory Valve Cap by pressing it firmly into the top of the Nebulizer.
5. Attach Tubing to Nebulizer Cup: Firmly press other end of the tubing to the Air Intake on the bottom of the Pari LC Plus.
6. Starting Treatment: Sit in a relaxed, upright position and turn compressor “ON”.
7. Nebulizer Position: Place the Nebulizer Mouthpiece on top of tongue and close lips around it. Take slow, deep breaths. As inhale, the Expiratory Valve closes.
8. Breathing: Mouthpiece: Inhale and exhale slowly through mouth. As exhale, the valve on the Mouthpiece opens to allow the exhaled mist to escape.
9. Mask: place mask over nose and mouth and inhale and exhale slowly.
10. Complete Treatment: Continue until the medication is gone or hear a slight “sputtering” sound. Turn compressor “OFF”.

How to clean LC Plus Nebulizer?

• Disconnect the tubing from the air intake on the bottom of the nebulizer cup.
• If there is any moisture (condensation) in the tubing, let the compressor run with only the tubing attached for 2-3 minutes. The warm air from the compressor will dry out the tubing. Alternatively, can dry the tubing by removing it from the compressor and hanging it up with the “ends down” to allow any moisture (condensation) to drain out and evaporate. Use a clean damp cloth to wipe the exterior of the tubing.
• Disassemble reusable nebulizer parts.
• Wash all parts with warm water and liquid dish soap. DO NOT WASH THE TUBING.
• Rinse the reusable nebulizer parts thoroughly with warm water and shake out water.
• Air dry or hand dry nebulizer parts on a clean, lint-free cloth. Reassemble nebulizer when parts are dry and store.
• User can also wash all parts of the reusable nebulizer on the top shelf of a dishwasher. DO NOT WASH TUBING. Place the reusable nebulizer parts in a dishwasher basket, then place the basket on the top rack of the dishwasher. Remove and dry the parts when the dishwasher cycle is complete.

Caution:

• The PARI LC PLUS is a handheld Nebulizer designed to aerosolize medication approved for nebulization. The PARI LC PLUS is intended for adult and pediatric patients consistent with the indications for the aerosol medication. Improper use can result in serious or fatal illness or injury. Nebulizer is not sterile.

Warning:

• Use only when prescribed by a physician and with the prescribed medication.

• Click Here For Pari LC Plus Reusable Nebulizer User Manual

Customer Reviews