Hpfy Nebulizer

Advanced Search

Precision Medical PowerVac Aspirator
Buy Precision Medical PowerVac Aspirator

Precision Medical PowerVac Aspirator

Brand/Manufacturer: PRECISION MEDICAL, INC
Hpfy Stores Save
  • Made in USA

Precision Medical PowerVac Aspirator is used to supply a continuous vacuum source, within the stated operating vacuum range. It features a dual protection system that consists of a float shut-off in the canister lid and an Inline Hydrophobic filter to prevent back flow of fluid as well as airborne contaminants from entering the pump. It has a unique, moveable canister holder which allows the caregiver to rotate the canister to either side of the unit for better placement near the point of use.

Estimated Shipping Time: 6 - 8 Weeks

Read More 

Features

  • Precision Medical PowerVac Aspirator includes:
    - Hospital grade power cord
    - 2000cc canister with lid
    - Adjustable canister holder
    - Hour meter
    - Protective filter
    - Durable infection control frinedly housing
  • ABS plastic cabinet is durable, attractive, easy-to-clean and infection control friendly
  • Safety is assured with the automatic resetting thermal limit switch which prevents the unit from overheating
  • High performance 1/5 horsepower pump delivers 0 to 26"Hg (0 to 660mmHg)
  • Compressor shelf is powder coated and durable
  • Pole, base arms and casters are smooth
  • Assured with the automatic resetting thermal limit switch which prevents the unit from overheating
  • Click here for User Manual

More Information

  • Place Aspirator near a properly grounded electrical receptacle on a table, floor or other horizontal, smooth, hard surface. Allow a minimum of 4 in (10 cm) clearance on all sides to ensure adequate air flow for cooling of Aspirator.
  • Ensure the On/Off Switch and Selector Knob are in the "OFF" position.
  • Ensure the Inline Hydrophobic Filter is properly connected to the vacuum port on Suction Canister lid. The Inline Hydrophobic Filter prevents liquid from entering the vacuum pump.
  • Plug the Aspirator into a properly grounded receptacle.
  • Press the On/Off Switch to the On position.
  • Block the patient connection on the Suction Canister and adjust the Vacuum Control Knob to the desired vacuum.
    • To INCREASE vacuum - Turn knob CLOCKWISE
    • To DECREASE vacuum - Turn knob COUNTERCLOCKWISE
  • Vacuum should be set as prescribed by your Physician or Healthcare Professional.
  • Connect one end of Patient Suction Tubing to the port on the Canister marked Patient Tubing.
  • Connect other end of Patient Suction Tubing to suction catheter and begin procedure as instructed by Healthcare Provider.
  • When procedure is completed, press the On/Off Switch to the OFF position.
  • Do not overfill the canister.
  • Empty the Suction Canister as follows:
    • Disconnect all suctioning tubing.
    • Remove the canister from its bracket and empty as instructed by your Physician or Healthcare Professional.
    • Replace Suction Canister and reconnect all suctioning tubing.

 

Precision PM61 PowerVac Aspirator Care and Cleaning

The Inline Hydrophobic Filter cannot be cleaned. If it becomes contaminated or clogged, it must be replaced.

 

To replace Inline Hydrophobic Filter

  • Disconnect filter assembly from Suction Canister and remove Suction Canister from the Aspirator.
  • Remove filter assembly from the Aspirator.
  • Dispose of filter.
  • Install new filter and reconnect tubing and elbow.
  • Tubing is single patient use only. Do not clean.

To replace Air Filters

  • Check both Air Filters on top rear of cabinet for dust build-up.
  • If dust build-up occurs, unplug Aspirator, remove Air Filters from their recessed areas and wash in warm, soapy water and rinse.
  • Absorb excess water from filters with a dry towel.
  • Return filters to their original locations.

Exterior Components Cleaning

  • Use a cloth or sponge dampened with soap and water.
  • Wipe dry with a clean cloth or paper towel.

 

Specification

Particulars Specifications
Dimensions
Length: 15.9" (40.3cm)
Width: 7.4" (18.7cm)
Height: 10.1" (25.7cm)
Weight
Unit Weight: 21lb (9.6kg)
Motor 120VAC, 60Hz, 5Amps
Operating Vacuum Range 0-622.3 mmHg (0-24.5 inHg)
Horsepower 1/5 Horsepower
Storage Conditions
Temperature: -4°F. to 104°F. (-20°C. to 40°C.)
Humidity: Max 95% Non-condensing
Operating Temperature Range 50°F. to 104°F. (10°C. to 40°C.)

Warranty

3 year warranty

Customer Reviews

Please enter your and your friends email address below.
Fields marked with * are compulsory
 
*
*
*
*


Submit Cancel
The selected product information has been successfully emailed to your friend.

Thank you for using www.shopnebulizer.com

Close